Part of the print is missing with that part of the platform clean ![]() If the images are there and connected then goto 5 and 6.ī. It is common for objects to be positioned above the first layer on the screen. If there is a break in the white to white in any layers then check the object on screen and support better or re-slice. There has to be white joining up with white in each layer. Step through the first layers of the stl on the screen and check that they are no all-black layers. ![]() Press play and run the same stl with the vat removed. The platform is clean and has no part of an object on it at all The screen comes on and the linear drive moves, but the print has a problem. Red led- screen connection issue (either the ribbon or the display port have a poor connection)Ĥ. The screen output connection on the main board supplies 11.5 – 12 volts to the screen driver board. If this is not on then open the machine to check connections and voltages. If the screen doesn’t have power then look through the bottom vent in the chassis base to see if the screen driver board LED is illuminated with a green led. Use 1 1/2mm Allen key to loosen all of then then tighten them so that it still runs smoothly. ![]() LC10 – Is the drive wobbly or does it make a grinding noise? Then the bushings are loose/misaligned. Press the ‘+50’ button on the control panel and see if the motor moves. Look at what is on the platform and goto 4 Yes– If Ring OK, but custom object is not OK- then it’s probably the.
0 Comments
Leave a Reply. |